1. In order to prevent the backflow of the medium, check valves should be installed on equipment, devices and pipelines;
2. Check valves are generally suitable for clean media and are not suitable for media containing solid particles and high viscosity;
3. Generally, horizontal lift check valves should be used on horizontal pipelines with a nominal diameter of 50mm;
4. The straight-through lift check valve can only be installed on horizontal pipelines;
5. For the water pump inlet pipeline, a bottom valve should be used. The bottom valve is generally only installed on the vertical pipe at the pump inlet, and the medium flows from bottom to top;
6. The lifting type has better sealing and greater fluid resistance than the swing type. The horizontal type should be installed on horizontal pipes, and the vertical type should be installed on vertical pipes;
7. The installation position of the swing check valve is not restricted. It can be installed on horizontal, vertical or inclined pipelines. If it is installed on a vertical pipeline, the medium flow direction must be from bottom to top;
8. The swing check valve should not be made into a small-diameter valve. It can be made into a very high working pressure. The nominal pressure can reach 42MPa, and the nominal diameter can also be very large, up to 2000mm or more. Depending on the materials of the shell and seals, it can be applied to any working medium and any working temperature range. The medium is water, steam, gas, corrosive medium, oil, medicine, etc. The working temperature range of the medium is between -196--800℃;
9. The swing check valve is suitable for low pressure and large diameter, and the installation location is limited;
10. The installation position of the butterfly check valve is not restricted and can be installed on horizontal pipelines, or on vertical or inclined pipelines;

